Skip to content

Hoists, Blocks & Clamps

147 SKUs

Showing 1–48 of 147 SKUs

Category image · Lifting & Rigging
Category image · Lifting & Rigging
Galvanized swivel eye snatch block with single sheave

Swivel Eye Snatch Block — 400–1,900 lbs WLL

1-1/2″ to 5″Hot dipped galvanized
Inquire
Stainless Steel Swivel Eye Pulley Single Wheel — dimension drawing

Stainless Steel Swivel Eye Pulley Single Wheel — 15–100 mm

Polished / electrophoretic coating15 mm to 100 mm
Inquire
Stainless Steel Double Wheel Swivel Pulley Block — dimension drawing

Stainless Steel Double Wheel Swivel Pulley Block — 25–50 mm

Polished / electrophoretic coating25 mm to 50 mm
Inquire
Category image · Lifting & Rigging

Stainless Steel Closed Type Block — 1,400–3,000 lbs WLL

PolishedType 304 or type 316 stainless steel
Inquire
Stainless steel body block with fixed eye and single sheave

Stainless Steel Body Block with Eye — 2–4″

Type 304 or type 316 stainless steelPolished
Inquire
Category image · Lifting & Rigging
Category image · Lifting & Rigging

Questions we get asked

About this range

01What is the difference between a push trolley and a geared trolley?
A push trolley is moved by pushing on the load; a geared trolley is driven by a hand chain, which gives finer positioning and is easier with heavier loads.
02Can a snatch block be used for lifting?
Yes, within its rated load — but the load on the block is not the load on the rope. With the rope turned through 180° the block carries about twice the line pull, so rate the block, its hook or shackle and its anchor point for that.
03Do the parts come with test certificates?
Yes. Each consignment ships with the manufacturer's test certificate. If your site needs more — third-party certification or witnessed proof testing — say so on the RFQ and we will confirm what we can arrange.
04Chain block or lever hoist — which do I need?
Use a chain block for vertical lifting from an overhead anchor, where the operator can stand clear and pull the hand chain. Use a lever hoist for short lifts, pulling and tensioning, and for work in confined spaces or at angles, since it is operated by a ratchet lever and needs no hand-chain drop. Lever hoists can be used in orientations other than vertical where their maker permits it. Both are rated by capacity and lift; check the hook-to-hook headroom on the table.
05Vertical or horizontal plate clamp — which do I need?
It depends on how the plate hangs during the lift. A vertical clamp grips one edge so a plate can hang vertically or be turned from flat to vertical, and is used singly or in pairs as its maker allows. Horizontal clamps grip the plate edge from below and are used in pairs or sets, on a spreader or multi-leg sling, to lift a plate held flat. Each clamp is rated for a plate thickness range as well as a maximum load, and some makers also set a minimum load, so check the clamp's table.
06What does 2/1 reeving mean on an electric wire rope hoist?
It means the hook block hangs on two falls of rope rather than one. With 2/1 reeving each fall carries roughly half the load, so the hoist can lift more with the same rope and drum, but the hook moves at half the rope speed and the drum gives half the lift of a 1/1 arrangement. Rated capacity, speed and lift height for each reeving are on the product page.