Skip to content

U-Bend Tubes

10 SKUs

Showing 1–10 of 10 SKUs

Carbon steel U-bend tubes nested by bend radius in a crate, spacer strip across the bends

Carbon Steel U-Bend Tubes

Bent from straight seamless or welded tubeA179; A192; A210; A214; A556
Inquire
Seamless U-bend tubes laid out by bend radius, with spacers between the rows

Alloy Steel U-Bend Tubes

A213 T11; A213 T22; A209 T1; A209 T1aBent from straight seamless or welded tube
Inquire
Ferritic stainless U-bend tubes nested by radius in a plastic-lined crate

Ferritic and Martensitic Stainless U-Bend Tubes

TP405; TP409; TP410; TP439; S44660Bent from straight seamless or welded tube
Inquire
Bright austenitic stainless U-bend tubes close up, polished legs and tight bends

Austenitic Stainless U-Bend Tubes

TP304/304L; TP316/316L; TP321; TP347; duplex S31803/S32205/S32750Austenitic Stainless U-Bend Tubes
Inquire
Pile of short-radius 180-degree return bends with plain cut ends

Return Bends — Short and Long Radius

Bent from straight seamless or welded tubeper family: SA179, SA192, SA210, SA213, SA334, SA335
Inquire
Nickel-alloy U-bend tubes nested by bend radius in a crate, spacers between rows

Nickel-Alloy U-Bend Tubes

Nickel-Alloy U-Bend TubesN04400; N06600; N06625; N08800; N08825
Inquire
Low-fin U-bend tubes nested by radius, finned legs with plain bent sections

Low-Fin U-Bend Tubes

Low-Fin U-Bend Tubesintegral
Inquire
Finned U-bend tubes with fins stopped short of the bend, plain U-bends at the ends

Finned U-Bend Tubes

Carbon steel, stainless steel, copper or copper alloy, to the standard on the orderFinned U-Bend Tubes
Inquire
Feedwater heater U-tubes nested by radius, numbered spacer boards between rows

Feedwater Heater U-Tubes

Feedwater Heater U-TubesTP304/304L/304N; TP316/316L; N08367; A556 A2/B2/C2; A803 TP439
Inquire
Copper-alloy U-bend tubes nested by radius, with spacers along the legs

Copper-Alloy U-Bend Tubes — ASTM B395

Bent from straight seamless or welded tubeC12200 etc.; C44300–C44500; C68700; C70600/C70620; C71500/C71520; C72200
Inquire

Questions we get asked

About this range

01How tight can a U-bend be?
A centreline radius of 1.5 × the tube OD can be bent. Bend tolerances are guaranteed from 2 × OD; below that, ovality and wall thinning need agreeing on the order.
02Are the bends heat treated?
To order. The bend and about 150 mm of each leg are stress-relieved or solution-annealed under ASTM A688, or a longer length where your project specification asks for it.