Skip to content

Topic

Cylinders, pumps & motors

The hoses and fittings carry the power; these three make it and use it. A pump turns shaft power into flow, a cylinder turns flow into straight-line force, a motor turns it back into torque — and almost every buying mistake with them comes from reading one number off a nameplate and ignoring the two beside it.

Articles
17
Reading
159 min
Updated

All 17 articles

October 202616

  1. Hydraulic power unit components: reservoirs, filters, bell housings, couplings and accumulators4 min
  2. Hydraulic control valves: directional, relief, flow control and flow dividers explained5 min
  3. Dump pumps, PTO pumps and clutch pumps: truck hydraulics from the gearbox to the hoist7 min
  4. 10,000 psi hydraulic cylinders and pumps: choosing, matching and using a 700 bar system safely10 min
  5. Hydraulic cylinder mounting styles: clevis, cross tube, trunnion, flange and the codes that name them8 min
  6. Gear, orbital, vane or piston: which hydraulic motor for the job?7 min
  7. Orbital hydraulic motors: how they work, Char-Lynn and Danfoss families, BM codes, mounts and shafts13 min
  8. Two-stage hydraulic pumps: how Hi-Lo log splitter pumps work, kick-down pressure and engine size7 min
  9. Vane pumps explained: Vickers V10 and V20, double pumps, Denison T6 and T7, and reading the model code10 min
  10. Hydraulic pump types: gear, vane and piston pumps compared, and how to choose10 min
  11. Telescopic hydraulic cylinders: how stages work, single vs double-acting, and sizing a dump hoist9 min
  12. Why a hydraulic cylinder drifts: piston seal, valve or oil — and how to test which10 min
  13. Hydraulic cylinders: the complete guide to types, parts, seals and selection9 min
  14. Welded vs tie-rod hydraulic cylinders: construction, pressure, repair and which to buy12 min
  15. Hydraulic motor torque and speed: how to size displacement, pressure and flow for the load9 min
  16. How to size a hydraulic pump: flow, pressure, drive power and the inlet nobody checks13 min

Topic guide

The short version

The three components, and the two numbers that size each one
ComponentConvertsForce or torque comes fromSpeed comes from
PumpShaft rotation into flowInput torque rises with displacement × pressureFlow = displacement × shaft speed
CylinderHighlightedFlow into straight-line forcePressure × piston (or annulus) areaFlow ÷ area
MotorFlow back into rotationPressure × displacementFlow ÷ displacement

The articles below are written to be used at the machine: how to read what is fitted, how to size what should replace it, and how to tell a worn component from a fault somewhere else in the circuit. Each one links to the shelves it describes, so a measurement taken from the guide can go straight into a quotation.

Replacing a cylinder, pump or motor?

Send the nameplate, or the bore, rod, stroke and mount of a cylinder, or the displacement, shaft and flange of a pump or motor. We will match it, quote the connections with it, and ship it as one consignment.

Plant-down? Call +971 52 2477942 — 24/7