Skip to content

Hydraulic Quick Couplers

424 SKUs19 brands

Showing 241–288 of 424 SKUs

Category image · Hoses & Fittings
Category image · Hoses & Fittings
Category image · Hoses & Fittings
Parker 70 Series Brass Couplers & Nipples, catalogue image 1

Parker 70 Series Brass Couplers & Nipples

Parker Hannifin70 Series Brass Couplers & Nipples
Inquire
Parker 60 Series Brass Industrial Couplings, catalogue image 1

Parker 60 Series Brass Industrial Couplings

Parker Hannifin60 Series Brass Industrial Couplings
Inquire
Parker 50 Series Pneumatic Couplers & Nipples, catalogue image 1

Parker 50 Series Pneumatic Couplers & Nipples

Parker Hannifin50 Series Pneumatic Couplers & Nipples
Inquire
Parker 30 Series Pneumatic Quick-Disconnect Couplers & Nipples, catalogue image 1

Parker 30 Series Pneumatic Quick-Disconnect Couplers & Nipples

Parker Hannifin30 Series Pneumatic Quick-Disconnect Couplers & Nipples
Inquire

Questions we get asked

About this range

01Will an ISO 7241 Series A coupler connect to Series B?
No. Series A and Series B are different interchanges with different dimensions; a coupler connects only to a mating half of the same series and size.
02When should I use a flush-face coupler?
Where dirt and spills matter: construction attachments, mobile machinery and anywhere the coupler is connected in the field. The flat faces wipe clean before connection and trap very little oil when disconnected.
03Can a coupler be connected under pressure?
Only one designed for it. Standard couplers should be connected with both sides depressurised; connect-under-pressure designs, such as the farm coupler on this shelf, are made to connect against residual pressure.
04Can I mate couplers from two different makers?
Yes, if both halves are made to the same interchange standard and size, such as ISO 16028 or ISO 7241 Series A. The standard fixes the mating dimensions, not flow, pressure drop or valve design, so a mixed pair may perform below either maker’s rating. Couplers sold as a maker’s own pattern, with no published interchange, only mate with that maker’s halves.
05Is a 1/2″ coupler a 1/2″ thread?
Not necessarily. The nominal size refers to the coupler body under its interchange standard, and the port thread on the back can be a different size and form — BSP, NPT, SAE O-ring boss or metric. Specify the interchange, the body size and the end thread separately, and check the flow at the body size.
06When should I choose a thread-to-connect coupler?
Where the line sees high pressure, heavy impulse or vibration that can work a push-to-connect sleeve loose, as on hydraulic hammers, breakers and some attachments. The halves are drawn together by a threaded sleeve rather than held by balls, so they stay connected under pressure spikes. They take longer to connect, so use push-to-connect where frequent changes matter more.
07What types of hydraulic quick coupler are there?
The shelf covers ISO 7241 Series A and B, ISO 16028 flush face, ISO 5675 tractor, HTMA tool, 10,000 psi jack and water-blast, thread-to-connect, ARO 210 and MIL-C-4109 air, SAE J1502 test-point, refrigerant and oil-sampling couplers, plus a pressure gauge test kit.
08How do hydraulic quick couplers work?
A quick coupler is a two-part connector that joins and separates a fluid line by hand. Where the coupler is valved, such as a self-sealing poppet type, each half seals on disconnection. Send your thread, size and pressure for a quote.