- 01Does an ORFS joint need sealant or tape?
- No — it seals on the face O-ring. Sealant on the thread or the face can stop the O-ring seating, and it contaminates the system.
- 02Which O-ring does an ORFS fitting use?
- A face O-ring sized for the fitting’s dash size, usually nitrile for mineral oil. Use the size specified for the fitting: one too thick or too thin will not seal.
- 03Why choose ORFS over JIC?
- ORFS tolerates vibration better because the seal is an elastomer rather than a metal seat. JIC is simpler and has no O-ring to replace. Most machines use one or the other; match what is fitted.
- 04Why won’t an ORFS -08 screw onto a JIC -08?
- Because ORFS uses a larger thread than JIC at the same dash size. ORFS threads are -04 9/16-18, -06 11/16-16, -08 13/16-16, -10 1-14, -12 1-3/16-12 and -16 1-7/16-12, whereas a JIC -08 is 3/4-16. The dash number gives the tube size, not the thread, so measure the thread and look for the face O-ring before ordering a replacement.
- 05Why does an ORFS joint leak when the line is pulled into place?
- Because the two flat faces must meet square, and a side load lifts one edge of the O-ring off its face. Unlike a cone, a flat face does not centre itself, so the line has to be routed and supported to reach the port without being forced. Seat the O-ring fully in its groove, start the nut by hand, bring the faces together squarely, then tighten to the specified torque.
- 06What does “captive seal” mean on an ORFS × metric adapter?
- It means the stud end’s seal sits in a retaining groove so it cannot fall out or be lost during assembly. The seal faces the port spot-face, so the thread itself carries no sealing duty and no sealant is needed. Replace the seal when the adapter is removed; a nicked or flattened seal is the usual cause of a weep at that end.
- 07What types of ORFS adapter are there?
- ORFS adapters are O-ring face seal fittings in straight, swivel, elbow, tee, bulkhead, plug and cap forms. They connect ORFS to ORFS, BSP, NPT, metric, metric flat-seal and SAE O-ring boss ends. Indus supplies them from Dubai.
- 08What sizes do ORFS adapters come in?
- ORFS adapters come in sizes -04 to -16, with ORFS threads from 9/16-18 to 1-7/16-12 UN/UNF. Listings state up to 415 bar (6000 psi) for several forms. The size table on this page lists each adapter.