- 01What documentation comes with a well-control hose?
- The certification its API specification requires, including the hydrostatic test record for the assembly, plus material certificates where the order calls for them. State your operator’s documentation requirements at quotation so they are prepared with the hose rather than after it.
- 02Can these hoses be used in sour service?
- Some can. Suitability depends on the construction, the liner and the fluid, so it is confirmed against your H2S partial pressure, temperature and pressure cycle rather than assumed. The drilling range includes a rotary and vibrator hose built for high-temperature sour service.
- 03Which brands are on this shelf?
- Continental ContiTech and Gates oilfield hose.
- 04What is the difference between rotary, vibrator and cement hose?
- Rotary hose is the flexible link between the standpipe and the swivel or top drive, carrying drilling mud to the string. Vibrator hose connects the mud pump to the standpipe manifold and absorbs the pump's pulsation. Cement hose carries cement slurry on cementing lines. All three are rotary drilling hose under API 7K, built and rated for their pressure and service.
- 05Bonded or unbonded flexible hose — what is the difference?
- In a bonded hose the rubber and steel reinforcement layers are vulcanised into one structure, covered by API 17K. In an unbonded flexible pipe separate polymer and steel layers slide over each other, covered by API 17J. Both are used for choke and kill lines; the specification named on the assembly's certificate tells you which you have.
- 06Which end connections can oilfield hose assemblies have?
- The connection your equipment uses: API 6A flanges, hubs, hammer unions such as Figure 1502 or 602, or threaded ends. The fittings are attached and tested by the hose manufacturer as part of the certified assembly, so specify both ends at quotation.
- 07What are tensioner and compensator hoses for?
- Offshore rigs use them on riser tensioners and drill-string compensators, which keep the riser and drill string under steady tension as the vessel heaves. The hoses carry high-pressure hydraulic fluid through constant flexing, so they are built and rated for cycle life as much as for pressure.
- 08Do you supply low-pressure oilfield hose?
- Yes — hose for mud, water, fuel, bulk-material and general oilfield service, including fire-resistant and flame-protected constructions, alongside the high-pressure drilling and well-control ranges.