Skip to content

Fracturing Equipment

13 SKUs1 brands

Showing 1–13 of 13 SKUs

Category image · Fracturing Equipment
Category image · Fracturing Equipment
Blue universal frac manifold of high-pressure pipe with swivel flanges and studded ends

Universal (E-Type) Frac Manifold, 15,000 to 20,000 psi

Indus HydraulicsFlange, union or hubAPI 6A (21st edition)
Inquire
Skid-mounted frac shunt manifold with three valve modules and connecting high-pressure pipe

Frac Shunt (Zipper) Manifold, 15,000 to 20,000 psi

Indus Hydraulics15,000 to 20,000 psi working pressureAPI 6A (21st edition)
Inquire
Skid-mounted high and low pressure frac manifold with plug valves and pump connections on a blue base

High and Low Pressure Frac Manifold (Missile), 15,000 to 20,000 psi

Indus Hydraulics15,000 to 20,000 psi working pressureManual plug valves
Inquire
Category image · Fracturing Equipment
Red frac tree stack with flanged frac valves, side outlets and a red handwheel

Frac Tree, API 6A, 5-1/8" to 7-1/16", 10,000 to 20,000 psi

Indus HydraulicsAPI 6A (21st edition), API 20E bolting10,000 to 20,000 psi working pressure
Inquire
Category image · Fracturing Equipment

Questions we get asked

About this range

01What equipment makes up a frac fleet?
Frac tanks and a hydration unit prepare the fluid; sand silos feed proppant to the blender, which mixes fluid, proppant and chemicals from the liquid additive system; the missile manifold distributes the slurry to the pumpers and gathers their high-pressure discharge; flow iron carries it to the wellhead; and the data van monitors and controls the job.
02How is frac pump horsepower calculated?
Hydraulic horsepower equals treating pressure in psi times rate in barrels per minute, divided by 40.8. A job at 9,000 psi and 80 bpm needs about 17,650 hydraulic horsepower, before allowing for losses and standby units.
03What is a frac missile?
A trailer-mounted manifold that sits between the blender and the pumpers. Its low-pressure side feeds slurry from the blender to each pumper's suction, and its high-pressure side collects their discharge into the treating line to the well.
04What does a hydration unit do?
It mixes gelling agent into water and holds it long enough to hydrate, so the fracturing fluid reaches the blender at the viscosity needed to carry proppant.
05What is a liquid additive system (LAS)?
A skid or trailer of tanks and metering pumps, with mass flowmeters, that doses liquid chemicals — friction reducers, crosslinkers, breakers and others — into the blender at controlled rates during the job.
06Is frac equipment built to order?
Yes. Each is built to the power, drive, capacity and certification you specify, and the lead time is confirmed at quotation.