R5 Textile-Cover Single Wire Braid Hose
Textile-cover single-wire-braid hose for fuel, oil, air, and refrigerant lines on legacy and military equipment. 3/16" – 2" (DN5 – DN51).
Key features
- Applicable Standard: SAE 100R5
- Construction Type: textile-cover
- Bore Size Range: 3/16" – 2" (DN5 – DN51)
- Max Working Pressure: 210 bar
- Min Burst Pressure: 840 bar
- Min Operating Temperature: -40 °C
- Max Operating Temperature: 121 °C
- Reinforcement: One layer of high-tensile steel wire braid under a textile-braid cover
- Applicable Standard
- SAE 100R5
- Construction Type
- textile-cover
- Bore Size Range
- 3/16" – 2" (DN5 – DN51)
- Max Working Pressure
- 210 bar
- Min Burst Pressure
- 840 bar
- Min Operating Temperature
- -40 °C
Product description
The R5 Textile-Cover Single Wire Braid Hose Textile-cover single-wire-braid hose for fuel, oil, air, and refrigerant lines on legacy and military equipment. Conforms to SAE 100R5.
Construction
- Tube: Synthetic rubber (NBR), oil-resistant
- Reinforcement: One layer of high-tensile steel wire braid under a textile-braid cover
- Cover: Textile braid (cotton/polyester), exposing the wire braid for inspection, smooth
Performance
Working pressures up to 210 bar at the smallest bore, with a minimum burst of 840 bar (safety factor 4:1). Continuous service from -40°C to 121°C, with the upper limit reduced for aggressive fluids — ask for a fluid compatibility chart if needed.
Applications
- Truck and bus fuel/oil lines
- Air and water service on industrial equipment
- Legacy hydraulic systems specifying textile-cover hose
Compliance
- SAE 100R5
Also available in
The same SAE 100R5 grade is stocked in Eaton Aeroquip and Eaton Winner in addition to the Parker Hannifin reference shown here. Tell us your brand preference on the RFQ and we will quote accordingly.
Companion grades
For modern rubber-cover dimensions see R1 1SN. For thermoplastic equivalents see R7 / R8.
Identification
| Parameter | Value |
|---|---|
| Applicable Standard | SAE 100R5 |
| Construction Type | textile-cover |
Dimensions
| Parameter | Value |
|---|---|
| Bore Size Range | 3/16" – 2" (DN5 – DN51) |
| Min Bend Radius | 75–335 mm by bore (75 mm at -04, 335 mm at -32) |
| Outside Diameter Range | 12.9–56.4 mm (-04 to -32) |
Performance
| Parameter | Value |
|---|---|
| Max Working Pressure | 210 bar |
| Min Burst Pressure | 840 bar |
| Safety Factor | 4:1 |
| Working Pressure Range | 210 bar at -04 down to 24 bar at -32 |
| Min Operating Temperature | -40 °C |
| Max Operating Temperature | 121 °C |
Construction
| Parameter | Value |
|---|---|
| Reinforcement | One layer of high-tensile steel wire braid under a textile-braid cover |
| Tube (Inner) Material | Synthetic rubber (NBR), oil-resistant |
| Cover Material | Textile braid (cotton/polyester), exposing the wire braid for inspection |
| Cover Finish | smooth |
Compliance
| Parameter | Value |
|---|---|
| Conductivity | non-conductive |
Commercial
| Parameter | Value |
|---|---|
| Sold By | per-metre |
Shipping & lead time
What standard does this hose comply with?▾
What is the maximum working pressure?▾
What temperature range is supported?▾
What bore sizes are available?▾
Is this hose conductive?▾
What end fittings are recommended?▾
How is this hose sold?▾
What is the typical lead time?▾
Shipped worldwide from our Dubai warehouse. Transit, routes and documentation for 126 destinations
From the blog
Written about this part
Failure analysis
Wire corrosion under an intact cover: how the water got in
A hose can look perfect and have rusted reinforcement. The cover is not waterproof once anything has broken its surface, and in a coastal climate the wire goes long before the rubber shows anything.
4 min read
Gulf operating conditions
Salt air at Jebel Ali and Mussafah: the clock runs faster on the coast
The corrosion mechanism is the same everywhere. What changes near the sea is the speed — and because the reinforcement corrodes invisibly, speed is the whole problem.
3 min read
Gulf operating conditions
Rated for 100 °C, working in a Gulf summer: what the number assumes
Hose temperature ratings are written for the fluid inside. In a UAE summer the hose is also being heated from outside, by air near 50 °C, by sun on the cover and by radiation off the machine — and none of that is in the rating.
4 min read
Engineers viewing this also looked at
R6 Single Fibre Braid Low-Pressure Hose
2SC Compact Two Wire Braid Hose
4SH Four-Spiral Heavy-Duty Hydraulic Hose
4SP Four-Spiral Hydraulic Hose
R1 1SC Compact Single Wire Braid Hose
R1 1SN Single Wire Braid Hydraulic Hose
R12 Four-Spiral High-Pressure Hose
