Skip to content

Pneumatics

796 SKUs33 brands

Showing 337–384 of 796 SKUs

Questions we get asked

About this range

01What is the difference between pneumatics and hydraulics?
Both use a pressurised fluid to do work. Pneumatics uses compressed air, normally at much lower pressure than hydraulics, so it suits fast, light-to-medium duty motion; it is clean, and spent air is simply exhausted to atmosphere. Because air is compressible, a pneumatic cylinder is less stiff when holding or positioning a load. Hydraulics uses oil, which is practically incompressible, at high pressure, so it gives large forces and firm holding, with the oil returned to a tank. The two do not share components: valves, seals, fittings and hose are built and rated for one or the other.
02How do I order a pneumatic part from Indus Hydraulics?
Send the maker's part number, quantity and delivery location. The number is usually on the nameplate, the valve body, the cylinder end cap or the old packaging. Each listing on these shelves groups one maker range, with its part numbers shown on the listing page. If you have no number, send a photograph and what you can measure: bore and stroke, port thread, tube size, function and voltage. We identify the part and quote on request.
03Which makers are in the pneumatics catalogue?
Parker Hannifin (including Legris and Transair), SMC, ARO, Wilkerson, Norgren, Numatics, Destaco, Dixon, Conrader, Kingston, Gast, Ingersoll Rand, Metal Work, Nitra, Boston Gear, Groz, Texas Pneumatic Tools, Hankison, Solberg, Aquatrol, Plast-O-Matic and others, plus a range of Indus Hydraulics own-label push-to-connect fittings. Every listing is sold under its maker's own brand and part number.
04Why does compressed air in the Gulf carry so much water?
Warm, humid air holds a lot of water vapour, and a compressor draws it in with the air. Compression concentrates that vapour, and as the hot air cools in the receiver and the pipework it condenses into liquid water, which then travels to valves, cylinders and tools. A filter removes liquid water but not vapour, so in hot, humid conditions a dryer, working drains on receivers and filters, and point-of-use filtration matter more, not less. Specify the dryness you need as an ISO 8573-1 water class.
05Can I mix metric and inch pneumatic components?
Only at interfaces you have checked. Metric tube and inch tube are different outside diameters (6 mm and 1/4 in, which is 6.35 mm, are not interchangeable), so a push-in fitting must match the tube. BSP and NPT threads do not mate. ISO cylinders and NFPA cylinders do not share mounting dimensions. An adapter can join two systems, but check each joint: tube to fitting, fitting to port, and cylinder to mount.
06Do you supply pneumatics outside the UAE?
Yes. We supply from Dubai across the GCC and quote for other markets on request. Give the delivery country on your enquiry so that we can quote freight and paperwork with the parts.