Single-Jacket Fire Hose, Polyurethane Liner

A single-jacket polyester fire hose with a polyurethane liner for fire brigades, industrial sites and general water transfer. One woven jacket keeps it light and quick to roll, so a crew can run out and recover lengths fast, while the polyurethane liner resists abrasion, chemicals and weathering.

Construction

• Liner: polyurethane, smooth bore
• Reinforcement and cover: single woven polyester jacket
• Colour: yellow

Where it fits

• Supply and attack lines where weight matters more than maximum pressure
• Industrial wash-down and temporary water transfer
• Hose reels and hose boxes on industrial sites

Care and testing

• Lay the hose out without kinks before charging it, and open the hydrant or pump valve slowly to avoid pressure surge.
• Keep it away from hot surfaces, sharp edges and dragged loads; use hose bridges where vehicles cross.
• After use, drain it, wash off oil, foam concentrate and mud, and let the jacket dry before it is rolled or racked.
• Store it out of direct sunlight, away from chemicals and in a dry place, rolled or flaked as your equipment requires.
• Inspect the jacket, liner and coupling bands before use, and service-test hoses at the interval your fire code sets — annually is common practice.

How to order

Send the bore, the length per hose (fire hose is usually supplied in 15, 20, 25 or 30 m lengths), the couplings and the standard your site, insurer or authority requires. We confirm construction, pressure rating and compliance before quoting, and supply hoses coupled, banded and pressure tested on request.