Manuli M00910 / M00920 Skive Ferrule

The M00910 / M00920 range is Manuli's skive ferrule for wire braid and wire spiral hydraulic hoses. It runs a larger outside diameter than the MULTIFIT M00110 family at the same bore, which is what lets it carry spiral reinforcement as well as braid.

Sizes and dimensions

The dimension sheet for this family also lists M00930-16 at DN25 and two M00920 references at DN10 and DN19 — both are shown in the table below.

D is the ferrule outside diameter and L the overall length, both in millimetres and both as supplied — they are not crimp dimensions. Across this series D runs 20.6–79.0 mm and L runs 26.0–72.0 mm.

Construction

• Ferrule type: skive
• Published by Manuli for wire braid and spiral hoses
• Part references in this series: M00910, M00920, M00930
• Bore coverage: DN5 – DN51 (3/16" – 2"), 12 references

Skiving exposes the reinforcement, so the crimp grips steel rather than rubber. It is the construction Manuli publishes for this series — do not substitute a no-skive ferrule for it without checking the hose grade.

Selecting a size

Read the bore off your hose — DN, dash or inch, whichever your drawing uses — and take the part reference on that row. The D and L columns are there for clearance: a ferrule has to fit the routing and the crimp die, and on tight installations that decides between two series more often than the bore does.

The crimp diameter is not on this sheet, and it is not a property of the ferrule alone — it comes from the hose grade and the fitting it is crimped with, on the die chart for your crimper. Send us the crimper model with the enquiry and we will quote against it.

How to order

Quote the part reference from the table, or give us the hose grade, the bore and the quantity and we will identify it. Indus supplies these ferrules loose or crimped as a finished assembly with the matching fitting at each end — say which when you send the enquiry.