Grade 100 Single-Leg Chain Sling, Foundry Hook Both Ends — Type SFF

Grade 100 single-leg chain sling made up with a foundry hook at each end. The chain and every fitting are Grade 100 alloy steel, quenched and tempered, and matched in size so that no component is the weak point.

What SFF means

Chain sling make-ups are named by a letter code read from the top down: S = single leg; F = foundry hook; F = foundry hook. So an SFF sling is a single leg sling with a foundry hook at each end.

Sizes and ratings

11 chain sizes, 6 mm to 26 mm. Working load limit 1.4 to 26.5 t in a straight vertical lift, at a 4:1 design factor. Used in a choke hitch the rating falls to 80% of the figure in the table. Each size has its own Indus part number below.

Grade 100 against Grade 80

Grade 100 chain carries about 25% more than Grade 80 chain of the same diameter, so a given load can often be lifted on a sling one chain size smaller and lighter. The table gives the standard Grade 100 ratings, worked on the same method as EN 818-4. Chain above 26 mm is made to order and its rating is confirmed on the quotation.

Choosing this make-up

A foundry hook has a wide, open throat with no latch, made for trunnions, ladle bails and handles too thick for a sling hook. With no latch, keep the load seated in the bowl of the hook.

Identification and certificate

Each sling carries a permanent tag with its serial number, chain size, grade, reach and working load limit, and ships with the manufacturer's test certificate. The rating on the tag and certificate is the one that governs the sling in service.

Ordering

Slings are made up to length. Quote the Indus part number for the chain size and the reach you need, measured from the bearing point of the top fitting to the bearing point of the hook, or send the load, the number of lifting points and the headroom and we will size the sling for you.