Universal Coupling European Type — Male End

The Universal Coupling European Type — Male End is part of the Sunpool (Taiwan) Universal Air Hose Couplings range supplied by Indus Hydraulics, an authorised distributor in the UAE.

Specifications

• Coupling Family: Universal Air Hose Couplings
• Size Range: Two Lugs: 1/4"-2"
• Materials Available: Carbon Steel; Brass; Stainless Steel; Malleable Iron
• Thread Form: BSPT

Manufacturer notes

• Universal air hose coupling-European Type Male End.
• American Type & Australia Type are available by request.

About the family

Universal air hose couplings — also called Chicago, claw or crowfoot-claw couplings — are interlocking half-couplings for compressed-air lines. Both halves are the same part, so any coupling mates with any other of the same pattern: they are pushed together, twisted a quarter turn, sealed on a gasket and locked with a safety pin or clip. Sunpool supplies the American, European and Australian lug patterns, which are not interchangeable with each other, in carbon steel, brass, stainless steel and malleable iron.

What it connects to

Any two couplings of the same pattern and lug count mate with each other — that is what "universal" means. A hose-end coupling joins hose to hose; a male- or female-end coupling puts a threaded port on the run; a blank end caps an idle line; a 3-way splits one supply into two. The American, European and Australian patterns look alike but the lug geometry differs, so they will not connect to one another — order the whole line in one pattern.

Where it is used

Universal couplings are the standard hose connector on compressed-air service across construction, quarrying, shipyards and workshops — jackhammers, rock drills, air tools, sandblast pots and compressor manifolds. They are chosen where hoses are coupled and uncoupled many times a shift and a threaded connection would be too slow, and where a crew needs to make up a line without tools.

Selection and service notes

Every connection needs a gasket to seal and a safety pin or clip to stop the coupling backing off under vibration. On compressed air above roughly 7 bar a whip-check cable should also be fitted across each joint: if a coupling does part under pressure, the cable stops the hose flailing. Inspect the lugs and the gasket seat at every make-up — a worn lug is what lets a coupling release under load.

How to order

Specify (a) the size, (b) the body material if more than one is listed, and (c) any thread, tail or gasket variant on the RFQ. Indus Hydraulics quotes this range to order from Dubai; engineering will confirm the manufacturer part number against your application, and where a variant is listed as available on request we will confirm the lead time for it before you commit.

Sunpool sizes

Sunpool part numbers are for carbon steel with a yellow zinc finish. They end -T for BSPT; Sunpool changes the ending to -N for NPT or -P for BSP. For 316 stainless steel, Sunpool replaces CS with S6.

Sizes and part numbers from Sunpool’s catalogue page for this part and its universal coupling part-number list, checked 7 October 2026.