Category
Hoses & Fittings
Hydraulic hose, fittings and adapters — wire-braid, spiral, compact and thermoplastic hose, crimp fittings and ferrules, SAE J518 flanges, quick couplers, and DIN 2353, BSP, JIC 37°, ORFS, metric and NPT thread forms. Carbon steel and SS316L.
Size range
Every size above is a part number you can quote from. Open any listing for its full table.
Delivery
Hoses & Fittings across the Gulf
Ex-stock from Dubai, delivered within 3 working days in the UAE.
Hose and fittings are the bulk of what leaves this warehouse, and they travel well: a crated batch of assemblies with its crimp records, or a box of adapters on an airway bill. Buyers outside the UAE usually order to a measured list rather than to a part number, because a hose is defined by its ends, its length and its route rather than by a code. Send those and we will quote against them.
Beyond the Gulf
- West & Central Africa
- Nigeria, Gabon, Republic of the Congo
- Southern Africa
- South Africa, Zimbabwe, Namibia
Adjustable Run Tee m JIC X m JIC X m Metric
ORFS Male O-Ring × Metric Thread Male Captive Seal
Male Female Thread Adaptor BSPT
Set of Bolts and Spring Washers
Male Connector m JIC X m SAE
Male Stud Connector NPT (DIN 2353)
45° Swivel Connector m JIC X f JIC
Swivel Nut Union
JIS Gas Male 60° Cone × JIS Gas Male 60° Cone
Metric Male O-Ring × Metric Female Run Tee
BSP Male 60° Seat or Bonded Seal × Butt-Weld Tube
JIC Male 74° Cone × BSP Male Captive Seal
Lock Nut for Bulkhead
45° Elbow JIS Gas Male 60° Cone × BSPT Male 60° Seat
Male Female Connector
Metric Male 74° Cone × Metric Male Adjustable Stud End
Male Connector m Metric X m Metric
45° Elbow JIC Male 74° Cone Bulkhead
45° Elbow JIC Male 74° Cone × NPT Male
Adjustable 45° Elbow m JIC X m Metric Flat
45° JIC Male 74° Cone
Male Stud Connector
Adjustable Run Tee m ORFS X m ORFS X m SAE
45° Metric Male O-Ring × Metric Male Adjustable Stud End
Metric Bite Type 45° Elbow Male Adjustable Stud End
BSP Male 60° Seat or Bonded Seal × NPT Female
From the blog
Written about this range
Assembly, crimping & certification
Getting a hydraulic hose made: what to bring and what we measure
Bring the old hose if you have it. If you do not, four measurements and two photographs will get the assembly built correctly first time.
3 min read
Thread & fitting identification
BSPP vs BSPT: why a parallel thread needs a seal and a tapered one does not
They share a thread form and a size designation, and they do not seal the same way. How to tell them apart on the bench, and what happens when they are mixed.
3 min read
Failure analysis
Hose routing: bend radius, twist and the failures they cause
Three installation faults account for a large share of premature hose failure, and all three are free to avoid at fitting time. What they look like and how to design them out.
3 min read